JHE MCU SH50A 2-3S MPU6000 F411 OSD 2.5A BEC Flight Controller 5A BLHELIS 4in1 ESC AIO 25X25mm for RC Cinewhoop Toothpick Ducted Drones

SH50A flight control 2-3S integrates 4in1 brushless ESC, uses MPU6000 sensor and connects through SPI bus, improves the sampling rate of the sensor, F4 main control increases the operating frequency of the program, provides higher control accuracy and faster response speed. The integrated OSD comes with Betaflight online tuning, which can be used in tinywhoop cinewhoop. Comes with 8MB black box, integrated 4in1 ESC, supports DSHOT signal output. Light weight, small size, low thickness and other advantages.

Receiver configuration, when SBUS/IBUS and DSM receiver input, please configure RX1 as input interface.

Flight control configuration:
CPU: STM32F411CEU6
Sensor: MPU-6000 three-axis accelerometer/three-axis gyroscope (SPI connection)
Power supply: 2-3S battery input (DC 7.4V-12.6V)
BEC: 5V 2.5A
Black box: 8MB
Receiver: PPM, SBUS, IBUS, Spektrum DSM2/DSMX, 1024/2048.
Built-in OSD interface
Led_Strip interface
BUZZER buzzer interface
UART2: TX2 (for image transmission), RX2
UART1: TX1, RX1 (for receiver)
Three sets of BEC output pads
Support BLheli suite ESC programming
Built-in voltage detection
Board size: 28.5*28.5MM
Screw hole spacing: 24.5*24.5MM diameter 3.0MM
Board weight: 3.3g

Brushless ESC configuration:
Power supply: 2-3S
Current: 5A continuous peak 7A (for 2 seconds)
Support BLHeliSuite programmable
Factory firmware: S_H_50_REV16_7.HEX
Signal support: D-shot150, D-shot300, D-shot600, Oneshot125, Multishot, PWM

Shipping list:
SH50A flight control x1 (the flight control ships by default using the pad method, and there are four other 3P*1.25MM direct plug sockets)
Power cord x2
XT30 x1