Spedix ES30 HV 30A 3-6S Blheli_S ESC

This is a new version Spedix ES30 BLHeli_S speed controller supporting 3- 6S LiPo batteries.

SSKaug stated the features of the new BLHeli_S program in the above thread as:

“BLHeli_S is an improved version of the base BLHeli code. BLHeli_S delivers a throttle response that is Smooth as Silk, and the main factor contributing to this, is that it uses hardware to generate motor PWM. Two MCUs support this for BLHeli_S, namely the BusyBee1 at 24MHz (EFM8BB10F8) and the BusyBee2 at 48MHz (EFM8BB21F16).

FEATURES Spedix ES30:

• D-SHOT Ready!
• BLHeli_S will have the same good Sync holding properties as base BLHeli. Maybe even better.
• BLHeli_S generally does Startup better than base BLHeli.
• BLHeli_S does damped light. Only.
• BLHeli_S has motor PWM that is Synchronous to the MCU master clock, as it is generated by hardware. This makes the motor Silent.
• BLHeli_S has very Small throttle Steps. The resolution varies between hardware configurations (MCU clock speed and driver type), and is between a nominal 512 steps and 2048 steps.
• BLHeli_S supports very high motor Speeds. A BB1 MCU will support 350k erpm, and the limit of the BB2 is not yet known, so the code is set to limit at 500k erpm.
• BLHeli_S supports regular 1-2ms input signal, as well as Oneshot125, Oneshot42 and Multishot. Autodetected when the ESC sees an input signal.
• Last and by no means least, is Simplicity. If you have a regular setup, just install and go fly (calibrate if your throttle range does not match BLHeli_S default). Or if you need to configure or update, just do so with the Simplicity offered by connecting to your ESCs through the FlightController, using BLHeliSuite and a USB cable.”

SPECIFICATIONS:

• Continuous Current: 30A
• Burst Current: 40A
• Input Voltage: 3S-6S LiPO
• Weight: 5.5g with wires and heat shrink wrap
• Dimensions: 25x13mm

PACKAGE INCLUDES:

• 1 x Spedix ES30A HV 3-6S ESC  BLHeli_S

Check our collection of ESC Spedix and other ESC here.